Motorola T2282 Manual de servicio descargar pdf (Pagina 33)

of 48 European Customer Services

T2282

6.1 Repair Introduction

The T2282 is divided into 3 main sections when it comes to part replacability: The Flip which contains

the speaker,battery connections, RTC battery and Vibrator. The housings that contain the main PCB

which contains RF / Logic circuitry. The third component is the the keypad and Display Assy. If the

RF / Logic board is required to be changed then a full service tranceiver should be ordered as there is

no replacement PCB available. Also a personality transfer would be necessary.

6.2 Mechanical repairs

Assembly replacement level troubleshooting and repair of the T2282 is limited to isolation and

replacement of the main mechanical parts only (See Exploded parts diagram and associated parts list)

6.3 Basic Modular Troubleshooting

The troubleshooting information in Table 2 shows some typical malfunction symptoms, and for the

corresponding verification and repair procedures refer to the disassembly instructions located in the

disassembly section of this manual. (Section 5).

NOTE

Defective Logic/RF assemblies must be replaced

with pre-tested, pre-phased assemblies

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 51 52

Sin comentarios

Motorola T2282 Manual de servicio Pagina 33