Motorola MP6000 Especificaciones Pagina 119

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 200
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 118
SITE PREPARATION AND INSTALLATION 3 - 33
Install Sensormatic Coils
The horizontal antenna is installed below the platter, on the middle housing, affixed to the housing with screws.
The vertical antenna is installed behind the vertical glass, also affixed to the scanner with screws. The coil tail
wires (with connectors) should be properly routed alongside the scanner to which the Sensormatic controller
box lead can connect.
Figure 3-42
Sensormatic Coil Screw Holes (Platter and Tower Bezel Removed)
To install the Sensormatic coils:
1. Remove the MP6000 platter.
2. Disconnect power to the MP6000.
3. Remove the MP6000 tower bezel by squeezing inward on both the left and right sides of the lower part of
the tower bezel, pushing its side snaps to disengage. Slide the tower bezel up and lift out. (See Figure 3-15
on page 3-17.)
4. Install the horizontal coil first:
a. Grasp the wide end of the coil, angling it towards the tower.
b. Insert the coil straight in and under the tower until it stops.
c. Once in, rotate the coil down around the horizontal window.
5. Install the vertical coil:
a. Unplug the USB cap (see Staging USB Flash Drive Cap/Port on page 1-11) and move out of the way (it
may interfere with the coil during this installation).
b. Position the coil in front of, and centered around the vertical window.
c. Push it straight back until the top of the coil rests against the stops.
d. Replace the cap.
Vista de pagina 118
1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 199 200

Comentarios a estos manuales

Sin comentarios