Motorola Symbol LS3408 Especificaciones Pagina 22
- Pagina / 354
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
1 - 4 Symbol LS3408 Product Reference Guide
4. Close the clamp, push it back into place and tighten the screws on the clamp to secure the cable into the
bottom of the scanner.
Figure 1-4
Closing the Cable Clamp
5. Connect the other end of the interface cable to the host (see the specific host chapter for information on host
connections).
Connecting Power (if required)
If the host does not provide power to the scanner, an external power connection is required to power the scanner.
To connect power:
1. Connect the interface cable to the bottom of the scanner, as described in Installing the Interface Cable on page
1-3.
2. Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
3. Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into
an AC outlet.
NOTE Different cables are required for different hosts. The connectors illustrated in each host chapter are
examples only. The connectors may be different than those illustrated, but the steps to connect the
scanner remain the same.
- Symbol LS3408 1
- Product Reference Guide 3
- Warranty 4
- Revision History 5
- Table of Contents 7
- Table of Contents vii 9
- Table of Contents ix 11
- Table of Contents xi 13
- About This Guide 15
- Notational Conventions 16
- Related Publications 16
- Service Information 17
- Chapter 1 Getting Started 19
- Unpacking the Scanner 20
- Setting Up the Scanner 21
- Removing the Interface Cable 23
- Configuring the Scanner 23
- Chapter 2 Scanning 25
- Beeper Definitions 26
- LED Definitions 27
- Scanning in Hand-Held Mode 27
- Optimum Scan Angles 28
- Scanning in Hands-Free Mode 29
- Decode Zone 30
- Scanning 2 - 7 31
- Specifications 33
- Troubleshooting 34
- Table 3-1 35
- Technical Specifications 36
- Table 3-2 37
- Scanner Signal Descriptions 38
- Table 3-3 39
- Chapter 4 User Preferences 41
- User Preferences 43
- *High Volume 44
- *Beep After Good Decode 45
- Level Trigger 46
- Two Stage - Option 1 46
- Two Stage - Option 2 46
- Aim Duration 47
- Table 5-1 51
- Keyboard Wedge Host Types 52
- *North American 53
- Keystroke Delay 55
- Intra-Keystroke Delay 56
- Caps Lock On 56
- *Do Not Convert Wedge Data 57
- FN1 Substitution 58
- Send Make and Break 58
- Keyboard Maps 59
- NCR 7052 32-KEY 60
- NCR 7052 58-KEY 60
- Table 5-2 62
- Table 5-3 65
- Table 5-4 66
- Table 5-5 68
- Table 5-6 69
- Table 5-7 70
- Chapter 6 RS-232 Interface 71
- RS-232 Default Parameters 73
- RS-232 Host Parameters 74
- RS-232 Interface 6 - 5 75
- RS-232 Host Types 76
- *Baud Rate 9600 77
- Parity (continued) 79
- Check Receive Errors 79
- *1 Stop Bit 80
- Standard RTS/CTS 81
- RTS/CTS Option 1 82
- RTS/CTS Option 2 82
- RTS/CTS Option 3 82
- Software Handshaking 83
- ACK/NAK with ENQ 84
- XON/XOFF 84
- *Minimum: 2 sec 85
- *Host: Low RTS 86
- *Minimum: 0 msec 87
- ASCII / Character Set 89
- Table 6-4 90
- RS-232 Interface 6 - 21 91
- RS-232 Interface 6 - 23 93
- Chapter 7 USB Interface 95
- Connecting a USB Interface 96
- USB Default Parameters 97
- USB Host Parameters 98
- USB Interface 7 - 5 99
- Spanish Windows 100
- Italian Windows 100
- Swedish Windows 100
- UK English Windows 100
- *No Delay (0 msec) 101
- USB CAPS Lock Override 102
- USB Ignore Unknown Characters 102
- Emulate Keypad 103
- Function Key Mapping 104
- Simulated Caps Lock 104
- Convert Case 105
- ASCII Character Set 106
- USB Interface 7 - 13 107
- Table 7-2 108
- USB Interface 7 - 15 109
- USB Interface 7 - 17 111
- Table 7-4 112
- USB Interface 7 - 19 113
- Table 7-6 114
- Table 7-5 114
- USB Interface 7 - 21 115
- Introduction 117
- IBM Default Parameters 119
- IBM 468X/469X Host Parameters 120
- IBM 468X/469X Interface 8 - 5 121
- Table 9-1 125
- Wand Emulation Host Types 126
- *80 msec 127
- *Bar High/Margin Low 127
- Ignore Unknown Characters 128
- Table 10-1 133
- Scanner Emulation Host 134
- Parameter Pass-Through 135
- Convert Newer Code Types 136
- Module Width 136
- Code 39 Full ASCII Conversion 137
- Transmission Timeout 138
- Leading Margin 140
- Check For Decode LED 141
- Chapter 11 123Scan 143
- 123Scan Parameter 144
- Chapter 12 Symbologies 145
- Symbology Default Parameters 146
- Symbologies 12 - 3 147
- Table 12-1 148
- *Enable UPC-A 149
- *Enable UPC-E 149
- *Disable UPC-E1 150
- *Enable EAN-13/JAN-13 150
- *Enable EAN-8/JAN-8 151
- *Disable Bookland EAN 151
- *Ignore Supplementals 153
- Enable 491 Supplemental Mode 154
- Symbologies 12 - 11 155
- UPC-A Check Digit 156
- UPC-E Check Digit 156
- UPC-E1 Check Digit 157
- *System Character 158
- Convert UPC-E to UPC-A 160
- Convert UPC-E1 to UPC-A 160
- *Disable EAN/JAN Zero Extend 161
- Code 128 162
- Enable/Disable ISBT 128 163
- *Enable Code 39 164
- *Disable Trioptic Code 39 164
- *Disable Code 32 Prefix 165
- Set Lengths for Code 39 166
- *Disable Code 39 Check Digit 167
- *Disable Code 39 Full ASCII 168
- *Disable Code 93 169
- *Disable Code 11 171
- Symbologies 12 - 29 173
- Transmit Code 11 Check Digits 174
- Interleaved 2 of 5 (I 2 of 5) 175
- *Disable 177
- Convert I 2 of 5 to EAN-13 178
- Discrete 2 of 5 (D 2 of 5) 179
- Codabar (NW - 7) 181
- *Disable CLSI Editing 183
- *Disable NOTIS Editing 183
- *Disable MSI 184
- Symbologies 12 - 41 185
- *One MSI Check Digit 186
- *MOD 10/MOD 10 187
- GS1 DataBar-14 188
- GS1 DataBar Expanded 189
- Redundancy Level 190
- Redundancy Level 3 191
- Redundancy Level 4 191
- Security Level 192
- Bi-directional Redundancy 193
- Scanning Sequence Examples 195
- Errors While Scanning 195
- Table 13-1 196
- Transmit Code ID Character 197
- Scan Angle 198
- Prefix/Suffix Values 198
- Scan Data Transmission Format 199
- <PREFIX> <DATA> 200
- Data Format Cancel 200
- *Disable No Read 201
- Synapse Interface 202
- Using ADF Bar Codes 204
- ADF Bar Code Menu Example 204
- Rule 2: The UPC Scanning Rule 205
- Alternate Rule Sets 205
- Default Rules 207
- Special Commands 208
- Quit Entering Rules 209
- Disable Rule Set 210
- Criteria 211
- Code Types (continued) 212
- Code Lengths 215
- Code Lengths (continued) 216
- Specific String at Start 221
- Any Message OK 221
- Numeric Keypad 222
- Numeric Keypad (continued) 223
- Rule Belongs To Set 224
- Send Data 225
- Send Data (continued) 226
- Setup Field(s) 229
- Move Cursor 230
- Send Pause 230
- Skip Ahead 231
- Skip Ahead (continued) 232
- Skip Back 233
- Skip Back (continued) 234
- Send Preset Value 234
- Remove All Spaces 235
- Crunch All Spaces 235
- Stop Space Removal 235
- Remove Leading Zeros 235
- Stop Zero Removal 235
- Pad Data with Spaces 236
- Pad Spaces To Length 29 241
- Pad Spaces To Length 30 241
- Stop Pad Spaces 241
- Pad Data with Zeros 242
- Pad Zeros To Length 29 247
- Pad Zeros To Length 30 247
- Stop Pad Zeros 247
- Beep Once 248
- Beep Twice 248
- Beep Three Times 248
- Control Characters 249
- Send Control \ 254
- Send Control ] 254
- Send Control 6 254
- Send Control 254
- Keyboard Characters 255
- Send ALT Characters 271
- Send Alt 6 276
- Send Alt 276
- Send Keypad Characters 277
- Send Escape Key 282
- Send Up Arrow Key 282
- Send Down Arrow Key 282
- Send Left Arrow Key 282
- Send Right Arrow Key 282
- Send Function Key 283
- Send Function Key (continued) 284
- Send GUI Y 298
- Send GUI Z 298
- Turn On/Off Rule Sets 299
- Turn Off Rule Set 1 300
- Turn Off Rule Set 2 300
- Turn Off Rule Set 3 300
- Turn Off Rule Set 4 300
- Alphanumeric Keyboard 301
- (Underscore) 305
- End of Message 312
- Table A-1 319
- Symbol Code Identifiers 325
- AIM Code Identifiers 326
- Programming Reference B - 3 327
- Table B-3 328
- Programming Reference B - 5 329
- Appendix C Sample Bar Codes 331
- 3 456789 0 12340 332
- 1234 5670 332
- 12345ABCDE 333
- Æ1234567890Æ 333
- A1234567890A 334
- 123456789 334
- 12345678912345 334
- Appendix D Numeric Bar Codes 335
- 3, 4, 5, 6 336
- Numeric Bar Codes D - 3 337
- Glossary 339
- Glossary - 3 341
- Glossary - 5 343
- Glossary - 7 345
- Numerics 347
- Index - 3 349
- Tell Us What You Think 351
Relacionado con productos y manuales para Lectores De Códigos De Barras Motorola Symbol LS3408
(404 paginas)
(28 paginas)
(2 paginas)
(2 paginas)
(158 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.051 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales