Motorola 7545MBWM Guía de usuario descargar pdf (Pagina 162)

4 - 4 Omnii Hand-Held with Windows CE 6.0 User Manual

Attaching the Pistol Grip

The pistol grip is attached to the back of the Omnii using the four threaded inserts in the upper part of the Omnii

casing (see Figure 4-2 Attaching the Pistol Grip on page 4-4). Four M3x6 Phillips head screws are provided.

• Position the pistol grip so that it fits snugly over the back of the unit and the holes in the pistol grip are

aligned with the threaded inserts on the back of the hand-held.

• Using a Phillips screwdriver, tighten the screws to a torque of 3 lbs-in (3kgf-cm) to secure the pistol grip

in place.

Figure 4-2

Attaching the Pistol Grip

Carrying and Protective Accessories

There are several Omnii carrying and protective accessories to help you work safely and comfortably.

Attaching Carrying Accessories

If your Omnii is not fitted with a hand strap, you can install it using the carrying accessory kit supplied.

You’ll need:

• A Phillips head screwdriver.

NOTE Prior to installation, make sure the trigger mechanism is securely snapped into the pis-

tol grip body and that the trigger operates properly.

NOTE The Omnii Hand-Held Computer is a body worn device, and to maintain compliance

with the FCC RF exposure guidelines, use a Motorola approved carrying case. Use of

non-approved accessories may violate FCC RF exposure guidelines.

IMPORTANT Do not use adhesives such as Loctite to secure screws on carrying acces-

sories. These chemicals may damage the plastic casing.

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 305 306

Sin comentarios

Motorola 7545MBWM Guía de usuario Pagina 162