HARDWARE PREPARATION AND INSTALLATION
2-18 MPC505EVBUM/D
2.3.3 Power Supply – EVB Interconnection
The EVB requires +5 Vdc @ 2 amp power supply for operation. Connector P7 pin 1 is +5 Vdc;
pins 2 and 3 are ground (shown in Figure 2-2). Use 16-22 AWG wire in the connector (supplied
with the board). EVB power supply interconnection for connector P7 is shown below.
Figure 2-2. Power Supply Connector (P7)
Comentarios a estos manuales