Motorola mT2a - PowerBroadband EthernetXD Switch Guía de usuario descargar pdf (Pagina 27)

Installation Steps

Motorola, Inc. 549453-001-00-a Page 27 of 51

Step 3

1. Align bottom hook to bracket using slight angle. Apply firm pressure to top and bottom to snap cover in place.

2. Install two #6 set screws (supplied) in the pre-drilled holes

Step 4

1. Connect the local AC power adapter to the WallPlate

2. Connect the analogue phone to the RJ11 phone jack

3. Connect an Ethernet cable (not supplied) to a laptop

The blue LED will flash slow, then fast, to indicate the unit is linking

When the LED stops flashing, the unit is linked

Step 5

After WallPlate blue LED is solid, connect with the mT2 switch using a valid IP address and HTTP or telnet

1) AC power adapter used during installation

2) Analog phone

3) Laptop used to test the connection and enable line power

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 50 51

Sin comentarios

Motorola mT2a - PowerBroadband EthernetXD Switch Guía de usuario Pagina 27