Motorola SB3100 Guía de usuario descargar pdf (Pagina 10)

INSTALLATION

ACT

LINK

ENET

CABLE

POWER

Ethernet to

computer

TV cable to

cable outlet

Power cord

to electrical

outlet

You must call your service provider to activate your service. You need to

provide the media access control (MAC) address. This address is found on

the barcode label marked HFC MAC ID on the rear panel. The address

format is 00:20:40:xx:xx:xx.

The installation of the SB3100 can be completed in a matter of minutes.

After you attach the three cables, you must configure your computer.

For a Single User

Connect the coaxial TV cable to the SB3100 connector marked

CABLE and the other end to the cable outlet or splitter. Hand-tighten

the connectors to avoid damaging them. You may need a 5-900 MHz

splitter if you have a TV connected to the cable outlet.

2 Connect the 10Base-T Ethernet cable to the SB3100 connector

marked ENET and the other end to the Ethernet jack on the back of

your computer.

3 Plug the power cord into the SB3100 connector marked POWER and

the other end to the electrical outlet.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Sin comentarios

Motorola SB3100 Guía de usuario Pagina 10