Motorola MC55 Enterprise Guía de usuario descargar pdf (Pagina 39)

Profile Editor Wizard 4 - 15

Key Entry Page

If either 40-Bit WEP or 128-Bit WEP is selected, the wizard proceeds to the key entry dialog box unless the Use

Passkey

check box was selected in the Encryption dialog box (see Figure 4-20 on page 4-13). The Key Entry dialog

box will be shown only if the authentication is set to

None. To enter the key information:

1. Enter the 40-bit or 128-bit keys into the fields.

2. Tap Next.

Figure 4-21

40-Bit and 128-Bit WEP Keys Dialog Boxes

Passkey Dialog

When selecting None as an authentication and WEP as an encryption, choose to enter a passkey by checking the

Use PassKey check box. The user is prompted to enter the passkey. For WEP, the Use PassKey checkbox is only

available if the authentication is

None.

When selecting

None as an authentication and TKIP as an encryption, the user must enter a passkey. The user

cannot enter a passkey if the encryption is

TKIP and the authentication is anything other than None.

When selecting

None as an authentication and AES as an encryption, the user must enter a passkey. The user

cannot enter a passkey if the encryption is

AES and the authentication is anything other than None.

Figure 4-22

Passkey Dialog Box

Tap

Next. The IP Address Entry dialog box displays.

IP Address Entry

Use the IP Address Entry dialog box to configure network address parameters: IP address, subnet mask, gateway,

DNS, and WINS.

Figure 4-23

IP Address Entry Dialog Box

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 83 84

Sin comentarios

Motorola MC55 Enterprise Guía de usuario Pagina 39