Motorola LM2000 Guía de instalación descargar pdf (Pagina 39)

2: Hardware Installation

DC 900-1331F 39

Step 7:

Freeway’s voltage rating must match the voltage rating of the electrical outlet into

which you are going to plug the unit. Freeways shipped in the United States are conﬁg-

ured for 110 - 120V. To determine the voltage rating for your Freeway, look at the label

on the voltage adjustment module on the back panel below the power cord socket. The

voltage rating in use is the one that is printed right-side up (its arrow is aligned with the

arrow at the bottom edge of the voltage adjustment module). For example, the voltage

rating shown in the left-hand panel of Figure 2–6 is 110 – 120V.

To change Freeway’s voltage rating, use the following procedure:

1. Make sure the power is off and unplug the power cord. The power switch is

located in the lower left corner of the back panel. To turn off the power, press the

rocker switch in the direction of the “0” symbol.

2. Insert a screwdriver blade in the notch at the top of the voltage adjustment mod-

ule which is located below the AC power socket on Freeway’s back panel. Loosen

the module and slide it out of the back panel.

3. Rotate the module 180 degrees. Reinsert the module in the back panel. Figure 2–6

shows how to change the voltage from 110V to 220V.

Voltage 1331

and 1332.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 85 86

Sin comentarios

Motorola LM2000 Guía de instalación Pagina 39