Motorola WS2000 - Wireless Switch - Network Management Device Especificaciones Pagina 207
- Pagina / 346
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Configuring HotSpot 8-3
8.2.1 Enabling Hotspot on a WLAN
To enable hotspot on a WLAN:
1. Click [Network Configuration] --> Wireless. The Wireless screen is displayed.
S
2. Select the Hotspot check box for the WLAN that will support Hotspot.
3. Click Apply to apply the changes made to this screen. Click Undo Changes to revert back to the previous
settings.
This enables hotspot on the particular WLAN.
NOTE: The HotSpot Session Timeout value controls the duration of inactivity after which the user is
timed out of the hotspot. The default value for HotSpot Session Timeout is 20 minutes. You can enter a
maximum of 1440 (1 day) minutes for this field.
- WS2000 Wireless Switch 1
- Contents 3
- Chapter 4: WAN Configuration 4
- Chapter 9: Using DDNS 7
- Chapter 12: WS2000 Use Cases 8
- Appendix A: Syslog Messages 9
- Product Overview 11
- 1.1.1 About this Document 12
- 1.1.2 Document Conventions 12
- 1.2 System Overview 13
- 1.3 Hardware Overview 14
- Location Function 15
- 1.4 Software Overview 16
- Getting Started 17
- Step 1: Install the Switch 18
- Getting Started 2-3 19
- Enable Subnet1 21
- Step 5: Configure Subnet1 22
- Getting Started 2-7 23
- Wireless Summary Area 25
- Setting the Encryption Method 27
- Step 9: Test Connectivity 28
- 2.2 Where to Go from Here? 28
- LAN/Subnet Configuration 29
- 3.1.1 Defining Subnets 30
- 3.2 Configuring Subnets 31
- 3.2.1 The DHCP Configuration 33
- 3.2.2 Advanced DHCP Settings 33
- 3.3 Configuring Subnet Access 35
- 3.5 Bridge Configuration 40
- 3.7 Configuring IP Filtering 43
- Transport Description 44
- 3.8 URL Filtering 46
- 3.9 Port Configuration 48
- WAN Configuration 49
- WAN Configuration 4-3 51
- 4.2.1 Disabling the Firewall 53
- 4.2.2 Setting the NAT Timeout 53
- 4.2.2.2 NAT Timeout Table 54
- 4.2.4 Enabling NetBIOS ALG 55
- Configuring the WS2000 56
- WAN Configuration 4-9 57
- WAN Configuration 4-11 59
- WAN Configuration 4-13 61
- 4.5 Configuring Static Routes 62
- WAN Configuration 4-15 63
- WAN Configuration 4-17 65
- 4.6.1 Creating a VPN Tunnel 66
- 4.6.2 Setting Up VPN Security 67
- WAN Configuration 4-21 69
- WAN Configuration 4-23 71
- WAN Configuration 4-25 73
- WAN Configuration 4-27 75
- WAN Configuration 4-29 77
- 4.8 Configuring DynDNS 79
- Wireless Configuration 81
- 5.1.1 WLAN Summary 83
- 5.1.1.1 WEP Shared Mode 84
- 5.1.1.2 SIP CAC Mode 84
- 5.1.1.3 Legacy Mode (AP300) 84
- 5.1.1.5 MU Inactivity Timeout 84
- 5.1.2.1 AP Deny List 85
- 5.2 Configuring Wireless LANs 86
- Wireless Configuration 5-7 87
- Reauthentication Settings 89
- Advanced Settings 90
- 5.3.8 KeyGuard 95
- 5.3.9 No Encryption 95
- 5.3.10 IP Filtering 95
- 5.4 Configuring Access Ports 97
- 5.5.2 Radio-Specific Settings 103
- 5.6.1 Radio Settings 105
- 5.6.2 Antenna Settings 106
- 5.6.3 Access Port Properties 106
- 5.6.4 Advanced Properties 106
- 5.9.3.1 The Approved AP List 114
- 5.9.3.2 The Rogue AP List 114
- 5.9.3.3 Rogue AP Containment 115
- Details About the Rogue AP 116
- 5.11.1 WIDS Configuration 120
- 5.11.2 Filtered MUs 121
- 5.12 Smart Scan 122
- 5.13 Self Heal 123
- 5.14 Mesh Settings 124
- 5.14.1 Mesh Base Setting 125
- 5.14.2 Mesh Client Setting 125
- Administrator and User Access 127
- LOG Column 129
- 6.2.4.1 Adding Groups 135
- 6.2.4.2 Deleting Groups 136
- 6.2.4.3 Adding Users 136
- Switch Administration 145
- Switch Administration 7-3 147
- Switch Administration 7-5 149
- Switch Administration 7-7 151
- Switch Administration 7-9 153
- 7.8.5.1 Setting Up the Switch 154
- Switch Administration 7-11 155
- Switch Administration 7-13 157
- 7.10 Updating Sensor Firmware 191
- 7.11 Configuring SNMP 192
- Switch Administration 7-49 193
- Switch Administration 7-51 195
- 7.11.6 Selecting Traps 196
- Switch Administration 7-53 197
- AP Traps 198
- Wireless 198
- 7.11.7 Setting RF Traps 199
- Switch Administration 7-57 201
- Configuring HotSpot 205
- 8.1 Overview 206
- 8.2 Configuring Hotspot 206
- Configuring HotSpot 8-3 207
- Configuring HotSpot 8-5 209
- Configuring HotSpot 8-7 211
- 8.2.6 Authentication (RADIUS) 213
- 8.2.7 Accounting (RADIUS) 213
- Using DDNS 215
- 9.1 Overview 216
- 9.2 Enabling DDNS 216
- Using DDNS 9-3 217
- Using DDNS 9-5 219
- 10.1 Overview 222
- 10.2.1 Mapping WLANs to VLANs 224
- Status & Statistics 225
- 11.1 WAN Statistics 226
- 11.2 Subnet Statistics 227
- 11.2.2 Subnet Stats 229
- 11.2.3 STP Stats 230
- 11.3 Wireless LAN Statistics 232
- 11.3.3.1 Information Section 235
- 11.3.3.2 Traffic Area 235
- 11.3.3.3 RF Status 235
- 11.4 Access Port Statistics 236
- Field Description 237
- 11.4.3.1 Information Section 238
- 11.4.3.2 Traffic Area 238
- 11.4.3.3 RF Status 239
- 11.4.3.4 Errors 239
- 11.6 Mesh Statistics 241
- WS2000 Use Cases 247
- 12.1 Retail Use Case 249
- 12.2 The Plan 249
- WS2000 Use Cases 12-5 251
- 12.3.2 Setting Access Control 252
- 12.3.3 The IP Address Plan 253
- 12.4 Configuring POS Subnet 254
- WS2000 Use Cases 12-9 255
- WS2000 Use Cases 12-11 257
- WS2000 Use Cases 12-13 259
- 12.9 Inspecting the Firewall 260
- WS2000 Use Cases 12-15 261
- WS2000 Use Cases 12-17 263
- WS2000 Use Cases 12-19 265
- WS2000 Use Cases 12-21 267
- WS2000 Use Cases 12-23 269
- WS2000 Use Cases 12-25 271
- WS2000 Use Cases 12-27 273
- 12.15 Configuring the Clients 275
- 12.16 Field Office Use Case 276
- 12.17 The Plan 276
- WS2000 Use Cases 12-31 277
- WS2000 Use Cases 12-33 279
- 12.19 Configuring the LAN 281
- WS2000 Use Cases 12-37 283
- WS2000 Use Cases 12-39 285
- WS2000 Use Cases 12-41 287
- 12.23 Adopting Access Ports 289
- 12.24 Configuring the WLANs 291
- 12.24.1 Security 292
- WS2000 Use Cases 12-47 293
- WLAN WS2000 Name ESSID 295
- Access Port Channel 296
- Engineering Offices 1 296
- Demo Room 4 296
- Sales and Marketing 7 296
- Administration 10 296
- WS2000 Use Cases 12-51 297
- WS2000 Use Cases 12-53 299
- WS2000 Use Cases 12-55 301
- 12.27 Configuring the VPN 303
- WS2000 Use Cases 12-59 305
- WS2000 Use Cases 12-61 307
- Syslog Messages 309
- A.1 Informational Log Entries 310
- A.2 Notice Log Entries 312
- A.3 Warning Log Entries 314
- A.4 Alert Log Entry 317
- A.5 Error-Level Log Entries 317
- A-11 319
- A-13 321
- A-15 323
- A-17 325
- A-19 327
- A-21 329
- System Component 330
- Level Log Message 330
- A.6 Debug-Level Log Entries 331
- A-25 333
- A.7 Emergency Log Entries 335
- Numerics 337
Relacionado con productos y manuales para Los conmutadores de red Motorola WS2000 - Wireless Switch - Network Management Device
(466 paginas)
(31 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.035 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales