Motorola WS2000 - Wireless Switch - Network Management Device Especificaciones Pagina 322
- Pagina / 346
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
A-14 WS2000 Wireless Switch System Reference Guide
SIP Module LOG_ERR SIP:Bye received with NULL call id
SIP Module LOG_ERR SIP:Status message received with NULL status code
SIP Module LOG_ERR SIP:Status message received with NULL call id
SIP Module LOG_ERR SIP:Status message received for an invalid call id [identifier]
SIP Module LOG_ERR SIP:Status message received at invalid state for call id [identifier]
SIP Module LOG_ERR SIP:Status message received at invalid state for call id [identifier]
SIP Module LOG_ERR SIP:status message received with invalid error code [number]
WIPS module LOG_ERR Could not read WIPS state
WIPS module LOG_ERR Could not open socket
WIPS module LOG_ERR Could not bind to socket
WIPS module LOG_ERR Could not set socket options
WIPS module LOG_ERR Error in receiving command
WIPS module LOG_ERR Bad sensor command received
WIPS module LOG_ERR WIPS: Invalid AD command [command] received
WIPS module LOG_ERR Invalid AP MAC. Can not convert to sensor
WIPS module LOG_ERR Can not convert the non-existing AP300 [MAC] to sensor
WIPS module LOG_ERR Invalid AP MAC. Can not revert to AP
WIPS module LOG_ERR Could not revert. Sensor [MAC] was not found
WIPS module LOG_ERR Could not get free buffer
WIPS module LOG_ERR Invalid AP MAC. Can not send cfg to sensor
WIPS module LOG_ERR AD packet with invalid MAC is received
WIPS module LOG_ERR Ack from an unknown sensor
WIPS module LOG_ERR Could not remove sensor [MAC]
WIPS module LOG_ERR Config from an unknown sensor
WIPS module LOG_ERR Configuration with bad length is received from [MAC]
WIPS module LOG_ERR Unexpected config reply from [MAC]
WIPS module LOG_ERR Could not send back data
WIPS module LOG_ERR Error reading configuration
WIPS module LOG_ERR Could not find RF port [MAC]
WIPS module LOG_ERR Invalid AP MAC. Can not get sensor config
System Component
Debug
Level Log Message
- WS2000 Wireless Switch 1
- Contents 3
- Chapter 4: WAN Configuration 4
- Chapter 9: Using DDNS 7
- Chapter 12: WS2000 Use Cases 8
- Appendix A: Syslog Messages 9
- Product Overview 11
- 1.1.1 About this Document 12
- 1.1.2 Document Conventions 12
- 1.2 System Overview 13
- 1.3 Hardware Overview 14
- Location Function 15
- 1.4 Software Overview 16
- Getting Started 17
- Step 1: Install the Switch 18
- Getting Started 2-3 19
- Enable Subnet1 21
- Step 5: Configure Subnet1 22
- Getting Started 2-7 23
- Wireless Summary Area 25
- Setting the Encryption Method 27
- Step 9: Test Connectivity 28
- 2.2 Where to Go from Here? 28
- LAN/Subnet Configuration 29
- 3.1.1 Defining Subnets 30
- 3.2 Configuring Subnets 31
- 3.2.1 The DHCP Configuration 33
- 3.2.2 Advanced DHCP Settings 33
- 3.3 Configuring Subnet Access 35
- 3.5 Bridge Configuration 40
- 3.7 Configuring IP Filtering 43
- Transport Description 44
- 3.8 URL Filtering 46
- 3.9 Port Configuration 48
- WAN Configuration 49
- WAN Configuration 4-3 51
- 4.2.1 Disabling the Firewall 53
- 4.2.2 Setting the NAT Timeout 53
- 4.2.2.2 NAT Timeout Table 54
- 4.2.4 Enabling NetBIOS ALG 55
- Configuring the WS2000 56
- WAN Configuration 4-9 57
- WAN Configuration 4-11 59
- WAN Configuration 4-13 61
- 4.5 Configuring Static Routes 62
- WAN Configuration 4-15 63
- WAN Configuration 4-17 65
- 4.6.1 Creating a VPN Tunnel 66
- 4.6.2 Setting Up VPN Security 67
- WAN Configuration 4-21 69
- WAN Configuration 4-23 71
- WAN Configuration 4-25 73
- WAN Configuration 4-27 75
- WAN Configuration 4-29 77
- 4.8 Configuring DynDNS 79
- Wireless Configuration 81
- 5.1.1 WLAN Summary 83
- 5.1.1.1 WEP Shared Mode 84
- 5.1.1.2 SIP CAC Mode 84
- 5.1.1.3 Legacy Mode (AP300) 84
- 5.1.1.5 MU Inactivity Timeout 84
- 5.1.2.1 AP Deny List 85
- 5.2 Configuring Wireless LANs 86
- Wireless Configuration 5-7 87
- Reauthentication Settings 89
- Advanced Settings 90
- 5.3.8 KeyGuard 95
- 5.3.9 No Encryption 95
- 5.3.10 IP Filtering 95
- 5.4 Configuring Access Ports 97
- 5.5.2 Radio-Specific Settings 103
- 5.6.1 Radio Settings 105
- 5.6.2 Antenna Settings 106
- 5.6.3 Access Port Properties 106
- 5.6.4 Advanced Properties 106
- 5.9.3.1 The Approved AP List 114
- 5.9.3.2 The Rogue AP List 114
- 5.9.3.3 Rogue AP Containment 115
- Details About the Rogue AP 116
- 5.11.1 WIDS Configuration 120
- 5.11.2 Filtered MUs 121
- 5.12 Smart Scan 122
- 5.13 Self Heal 123
- 5.14 Mesh Settings 124
- 5.14.1 Mesh Base Setting 125
- 5.14.2 Mesh Client Setting 125
- Administrator and User Access 127
- LOG Column 129
- 6.2.4.1 Adding Groups 135
- 6.2.4.2 Deleting Groups 136
- 6.2.4.3 Adding Users 136
- Switch Administration 145
- Switch Administration 7-3 147
- Switch Administration 7-5 149
- Switch Administration 7-7 151
- Switch Administration 7-9 153
- 7.8.5.1 Setting Up the Switch 154
- Switch Administration 7-11 155
- Switch Administration 7-13 157
- 7.10 Updating Sensor Firmware 191
- 7.11 Configuring SNMP 192
- Switch Administration 7-49 193
- Switch Administration 7-51 195
- 7.11.6 Selecting Traps 196
- Switch Administration 7-53 197
- AP Traps 198
- Wireless 198
- 7.11.7 Setting RF Traps 199
- Switch Administration 7-57 201
- Configuring HotSpot 205
- 8.1 Overview 206
- 8.2 Configuring Hotspot 206
- Configuring HotSpot 8-3 207
- Configuring HotSpot 8-5 209
- Configuring HotSpot 8-7 211
- 8.2.6 Authentication (RADIUS) 213
- 8.2.7 Accounting (RADIUS) 213
- Using DDNS 215
- 9.1 Overview 216
- 9.2 Enabling DDNS 216
- Using DDNS 9-3 217
- Using DDNS 9-5 219
- 10.1 Overview 222
- 10.2.1 Mapping WLANs to VLANs 224
- Status & Statistics 225
- 11.1 WAN Statistics 226
- 11.2 Subnet Statistics 227
- 11.2.2 Subnet Stats 229
- 11.2.3 STP Stats 230
- 11.3 Wireless LAN Statistics 232
- 11.3.3.1 Information Section 235
- 11.3.3.2 Traffic Area 235
- 11.3.3.3 RF Status 235
- 11.4 Access Port Statistics 236
- Field Description 237
- 11.4.3.1 Information Section 238
- 11.4.3.2 Traffic Area 238
- 11.4.3.3 RF Status 239
- 11.4.3.4 Errors 239
- 11.6 Mesh Statistics 241
- WS2000 Use Cases 247
- 12.1 Retail Use Case 249
- 12.2 The Plan 249
- WS2000 Use Cases 12-5 251
- 12.3.2 Setting Access Control 252
- 12.3.3 The IP Address Plan 253
- 12.4 Configuring POS Subnet 254
- WS2000 Use Cases 12-9 255
- WS2000 Use Cases 12-11 257
- WS2000 Use Cases 12-13 259
- 12.9 Inspecting the Firewall 260
- WS2000 Use Cases 12-15 261
- WS2000 Use Cases 12-17 263
- WS2000 Use Cases 12-19 265
- WS2000 Use Cases 12-21 267
- WS2000 Use Cases 12-23 269
- WS2000 Use Cases 12-25 271
- WS2000 Use Cases 12-27 273
- 12.15 Configuring the Clients 275
- 12.16 Field Office Use Case 276
- 12.17 The Plan 276
- WS2000 Use Cases 12-31 277
- WS2000 Use Cases 12-33 279
- 12.19 Configuring the LAN 281
- WS2000 Use Cases 12-37 283
- WS2000 Use Cases 12-39 285
- WS2000 Use Cases 12-41 287
- 12.23 Adopting Access Ports 289
- 12.24 Configuring the WLANs 291
- 12.24.1 Security 292
- WS2000 Use Cases 12-47 293
- WLAN WS2000 Name ESSID 295
- Access Port Channel 296
- Engineering Offices 1 296
- Demo Room 4 296
- Sales and Marketing 7 296
- Administration 10 296
- WS2000 Use Cases 12-51 297
- WS2000 Use Cases 12-53 299
- WS2000 Use Cases 12-55 301
- 12.27 Configuring the VPN 303
- WS2000 Use Cases 12-59 305
- WS2000 Use Cases 12-61 307
- Syslog Messages 309
- A.1 Informational Log Entries 310
- A.2 Notice Log Entries 312
- A.3 Warning Log Entries 314
- A.4 Alert Log Entry 317
- A.5 Error-Level Log Entries 317
- A-11 319
- A-13 321
- A-15 323
- A-17 325
- A-19 327
- A-21 329
- System Component 330
- Level Log Message 330
- A.6 Debug-Level Log Entries 331
- A-25 333
- A.7 Emergency Log Entries 335
- Numerics 337
Relacionado con productos y manuales para Los conmutadores de red Motorola WS2000 - Wireless Switch - Network Management Device
(466 paginas)
(31 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.047 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales