Motorola BSR 64000 Guía para resolver problemas descargar pdf (Pagina 102)

BSR Troubleshooting Guide

6-102

Follow these steps to ensure that the correct version of RIP is running on the BSR:

1. To determine which version of RIP is configured on the BSR, use the debug ip

rip command in RIP Configuration mode, as shown in the following example:

RDN(config-rip)#debug ip rip

2. Review the debug ip rip command output and identify the cause of the problem.

Use no debug ip rip to turn off debugging.

3. If the wrong version of RIP is configured for receiving RIP packets, use the ip rip

receive version command in RIP Configuration mode, as shown in the following

example:

RDN(config-rip)#ip rip receive version <option>

where:

option is the for the version or versions of RIP that are accepted over the

interface.

Table 6-1 lists the available command options:

4. If the wrong version of RIP is configured for sending RIP packets, use the ip rip

send version command in RIP Configuration mode, as shown in the following

example:

RDN(config-rip)#ip rip send version <option>

where:

option is the for the version or versions of RIP that are accepted over the

interface.

Table 6-1 ip rip receive version Command Options

Option Description

0 The BSR can receive RIP version 1 and 2 packets.

1 The BSR can receive only RIP version 1 packets.

2 The BSR can receive only RIP version 2 packets.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 145 146

Sin comentarios

Motorola BSR 64000 Guía para resolver problemas Pagina 102