Showtime East Digital IRD Rollout DSR 4410 Installation Instructions
Please note that the digital carrier is on AMC 11, Transponder 19, a different satellite and transponder than
the current analog signal.
3.5 Tuning Satellite Feed
6. From the Main Menu use the ◄►to select Install, press ENTER.
7. Use the ▼▲ buttons to select the MANUAL TUNE menu
8. From MANUAL TUNE menu, verify Input = Port 0 and Mode = Xpndr
9. Use the ◄► buttons to select Xpndr, press ENTER.
10. Use the ▲▼ buttons to change the transponder to 19, press ENTER to save.
11. From the MANUAL TUNE menu verify the L-Freq = 1075.00 MHz (Xpndr19)
12. Use the ◄► buttons to move the cursor to MANUAL TUNE.
13. Use the ▼button to move the cursor to the MODULATION.
14. Use the ◄► buttons to select Mode, press ENTER.
15. Use the ▲▼ buttons to select DCII-MAN, press ENTER.
16. Use the ► button to select Symbol Code Format, press ENTER.
17. From the Modulation Menu Press the ► twice to highlight Symbol 19.51, press
ENTER.
18. Use the ▼▲ buttons to select ¾ combined, press ENTER to save.
19. Press ►to move the cursor to MODULATION.
20. Press ENTER to display the Main Menu.
21. Wait for the SIGNAL green LED to illuminate. This can take up to 2 minutes. Do not
proceed to the next step if the SIGNAL LED does not come on; proceed to Basic
Troubleshooting Tips for No Signal lock in Section 4.
3.6 Configuring Channel Parameters
Before viewing video and audio on the DSR-4410 IRD, the operator must select the correct Virtual Channel
Table (VCT) ID and Channel number. In addition the IRD must be authorized for the intended service. Follow
the steps below to enter the correct VCT ID and Channel number.
22. From the Main Menu use the ◄►button to select Channel, press ENTER.
23. Use the ► button to move the cursor to VCT, press ENTER.
24. Use the ▼▲◄► buttons to change the VCT number to 0183, press ENTER to save.
25. Use the ► button to move the cursor to Chnl, press ENTER.
26. Use the ▼▲◄► buttons to change the channel number to 0400, press ENTER to save.
27. Use the ◄►button to move the cursor to CHANNEL, Press ENTER to return to the
Main Menu.
28. If you receive an error when selecting the channel contact Motorola at 1-866-276-4327.
3.7 CUE Tones
The DSR-4410 will be able to generate cue tones when commanded over the satellite link. If these internally
generated cue tones are used, connect the 600 Ohm differential Cue Tone+ and Cue Tone- terminals on the
DSR-4410 to the device that will be accepting the tones. The cautions on cable and grounding noted in the
audio instructions above also apply to cue tones.
Note: Showtime East feed runs commercial free. Please proceed to section 3.8.
All information contained in this document is Proprietary to Motorola Inc. and is disseminated solely for the
convenience and support of its customers.
6 / 7
(106 paginas)
(20 paginas)
(3 paginas)
(1 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales