Motorola C200-1-5 Información técnica descargar pdf (Pagina 60)

Programming L3149B (C200) Advanced Tone Remote Desk Set

Manual Paging

Page PTT Frequency

If the system is configured such that pages should be transmitted on a particular channel, the page PTT

frequency may be used. This parameter allows the selection of the page PTT frequency for all manual

pages. In addition the desk set can be configured to remain on the page PTT frequency until manually

changed by the operator.

Keep Page PTT Frequency after Page

If a page PTT frequency is used, the unit will normally revert to the previous function tone after a page is

complete and the talk time has expired. This may not be desirable if the operator wishes to remain on the

page channel to further transmit to the paged party. In this case, setting this parameter causes the unit to

stay on the page channel until the operator manually changes the channel back.

OTE: This parameter is available only if Page PTT Frequency is not Disabled.

Paging PTT Pretime

This parameter sets the length of time after the beginning of the transmission before the paging tones are

transmitted. For tone control, this time begins at the end of the function tone. The valid range is 0 ms to

2000 ms in 10 ms increments.

OTE: This parameter affects alias paging as well.

6 dB/Octave De-emphasis Enable

This parameter enables/disables 6 dB/octave de-emphasis. If this parameter is enabled, all paging is

de-emphasized 6 dB/octave before being put on wire lines. This is helpful when paging tones are going

to be in the 300 Hz to 500 Hz range. If this parameter is disabled, all paging is put on wire lines flat.

OTE: This parameter affects alias paging as well. De-emphasis is not applied to DTMF paging.

DTMF Paging

Maximum Digits Allowed from Keyboard

This parameter controls the maximum number of digits that may be entered by the operator. The valid

range is 0 to 6.

DTMF Interdigit Time

This parameter controls the duration of the DTMF digit and pause between digits (digit time and pause

are always equal). The valid range is 50 ms to 550 ms in 50 ms increments.

OTE: This parameter affects alias paging as well.

DTMF Paging Preamble

Allows you to preset up to nine DTMF preamble digits for each channel. The valid range for each digit

is 0-9, A–F, # and *.

TALK NOW Timer for DTMF Paging

This parameter allows selection of the length of time a user is allowed to talk after the paging signal. If

the

TRANSMIT button is pressed during TALK NOW time, the unit continues to transmit until the button

is released. The range is 0 to 45 seconds. If 0 seconds is selected, the operator is not allowed to talk

after the page.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 91 92

Sin comentarios

Motorola C200-1-5 Información técnica Pagina 60