Motorola AP-650 Series Guía de instalación descargar pdf (Pagina 16)

Hardware Installation

2.6.2 Wall Mount Procedure

1. Orient the case on the wall by its width or length.

2. Using the arrows on one edge of the case as guides, move the edge to the midline of the

mounting area and mark points on the midline for the screws.

3. At each point, drill a hole in the wall, insert an anchor, screw into the anchor the wall mounting

screw and stop when there is 1mm between the screw head and the wall.

4. If required, loop a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.) in diameter, around

the tie post and secure the loop.

5. If required, install and attach a security cable to the unit’s lock port.

NOTE When pre-drilling a hole the recommended hole size is 2.8mm (0.11in.) if

the screws are going directly into the wall and 6mm (0.23in.) if the

provided wall anchors are being used.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

Sin comentarios

Motorola AP-650 Series Guía de instalación Pagina 16