
Getting Started 1 - 5
Trigger Swivel Assembly - Change Trigger Position
The Imager is worn on the index and middle fingers, and triggered with the thumb. The Trigger Swivel Assembly of
the Imager rotates to provide left-hand or right-hand use.
To change the position of the Trigger:
1. From the bottom of Imager, hold and pull the Comfort Pad off the Imager.
Figure 1-3
Change Trigger Position - Removal of Finger Strap and Comfort Pad
2. Determine whether the Imager is used on the right or left hand and rotate the Trigger Swivel Assembly.
Figure 1-4
Change Trigger Swivel Assembly Position
3. Rotate the Trigger Swivel Assembly so that the Scan Trigger is positioned next to the thumb when the Imager
is placed on the index and middle fingers.
4. Position the Comfort Pad onto the Imager.
5. Press the Comfort Pad onto the Imager. When properly installed, the Comfort Pad locks into place.
6. Insert the Finger Strap into the Strap Buckle.
NOTE When removing the Comfort Pad off the Imager, It is not necessary to remove the Finger Strap from
the Trigger Swivel Assembly.
CAUTION The Trigger Swivel Assembly only rotates 180° around the front of the scan assembly. Do not rotate
the Trigger Swivel Assembly past the designed stops.
Finger Strap
Strap Buckle
Comfort Pad
Trigger
Swivel
Assembly
Trigger Swivel Assembly
Scan Trigger
Comentarios a estos manuales