Motorola T3 Guía de usuario descargar pdf (Pagina 15)

Motorola, Inc Page 15 of 24

Install the Switch in a standard EIA-19 equipment rack using the provided mounting ears. Install

other network equipment such as routers and Ethernet switches.

Premises termination with the XLP-6824 is normally done by directly punching the wire pairs to a

termination block. No cross connect is required since the XLP system is not compatible with

telephone wiring in the same wire pair.

1) Install a jumper wire (2pr or 4pr) between the keyed connector and the premises wiring

a) Two or Four wire pairs per keyed connector, depending on the available premises wire

pairs

2) Install a jumper wire between the end-point termination and the key connector

For a detailed list of commands, refer to the XLP-6800 Command Reference guide or XLP-6800

User Guide. Details are available for configuring IP address, ACL, SNMP, VLANs, QoS, SNTP,

IGMP, etc.

Default IP address: 192.168.1.3

Default user name: admin

Default password: <blank>

1) Login using telnet or the serial console

2) Issue these commands

a) interface dsl config port(1-4) max-down 40 max-up 40

b) interface dsl power enable port(1-4)

c) interface remote enable port(1-4)-(1-2)

d) interface remote power enable port(1-4)-(1-2)

3) Use these commands to monitor the system

a) show interface dsl status

b) show interface dsl statistics

c) show syslog messages level trace

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Sin comentarios

Motorola T3 Guía de usuario Pagina 15