Motorola T3 Guía de usuario descargar pdf (Pagina 9)

Motorola, Inc Page 9 of 24

Cross connect wire spool, 300m One spool for ~100 rooms, as needed

19" Equipment Rack As needed

Misc (AC power strip, wire management, etc) As needed

UPS or line conditioning power As needed

Aggregation Layer2 Ethernet Switch As needed

Note on Filters

Only Motorola filters can be used when line power is enabled. Typical ADSL type filters do not

have enough filtering capability.

–

Install the T3 Switch and termination blocks

Install the Switch in a standard EIA-19 equipment rack using the provided mounting ears. Install

other network equipment such as routers and Ethernet switches.

Termination blocks should be located close to the existing Room Termination blocks to facilitate

installation of the cross connect wires.

Connect an RJ21 Amphenol cable between the LINE side connector on the Motorola T3 Switch

and the Left side of the new termination block.

Connect an RJ21 Amphenol cable between the PHONE side connector on the Motorola T3

Switch and the Right side of the new termination block. The PHONE connector will carry line

Power + xDSL + telephone toward the Motorola WallPlate.

New Termination Block installed

Siemens S66M2-5W-TP or similar

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Sin comentarios

Motorola T3 Guía de usuario Pagina 9