Motorola USB08 Instrucciones de operaciones descargar pdf (Pagina 86)

APPENDIX E - COMMAND-LINE ERROR MESSAGE SUMMARY

Command Line Errors

There are numerous ways in which what is typed on the command line may not be appropriate. If

Xplor8 detects an error, it replies by echoing the command line to the Command history window with

a left-pointing arrow and an explanatory message. The following table lists all the errors that may

occur. Most are self-explanatory; brief guidance notes are included where appropriate:

Command line error message Notes

Unrecognized command Basic error message

Project error - command not available Project file has errors. Open 'Settings', then

click 'OK' for a list of the errors

Not available when disconnected COM port is closed

Requires Monitor Mode MCU needs to be running the Monitor

firmware. Reset the MCU with the necessary

voltages on its pins

Not available in Monitor Mode

Cannot interrupt running program Command cannot be used while a program is

being run on the MCU

Cannot interrupt while tracing Command cannot be used while a program is

being traced on the MCU

Not available in User mode

Already disconnected

Already connected

Monitor/User switch not available The General Purpose switching function has

not been set up

Already in connected/monitor mode

Already in user mode

Address(es) overlap undefined memory Command arguments, or the loading

addresses in an S19 file, overlap undefined

memory

Address(es) overlap RAM (should never occur)

Address(es) overlapI/O Registers Command arguments, or the loading

addresses in an S19 file, overlap the I/O

registers

Address(es) overlap ROM Command arguments, or the loading

addresses in an S19 file, overlap undefined

ROM

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 99 100

Sin comentarios

Motorola USB08 Instrucciones de operaciones Pagina 86