
Using the FR68 Series
36
LED Indicators
The FR68 Series has three LED indicators. The Scan/Decode LED indicates status for bar code
scanning. The Charging/Battery Status LED indicates battery charging and status. The Radio Status
LED indicates radio status. Table 2-8 describes the LED indications.
Figure 2-9 LED Indicators
1. Scan/Decode LED
2. Charging LED
3. Radio Status LED
Table 2-6 LED Indications
LED Status Indication
Scan/Decode LED
Single blinking green Barcode was successfully decoded.
Solid red Laser enabled, scanning in process
System Led (Amber blink) The behavior of this LED controlled by Microsoft
system.
Off Not enabled
Charging/Battery Status LED
Off
FR68 Series is not charging.
FR68 Series is not inserted correctly in the cradle
or connected to a power source. Charger/cradle is
not powered.
Slow blinking amber
FR68 Series is charging.
Solid green
Charging complete.
Note: When the battery is initially inserted in the
FR68 Series, the amber LED flashes once if the
battery power is low or the battery is not fully
inserted.
Fast blinking amber
Battery over-temperature condition
Fast blinking red
Charging error, e.g.:
• Temperature is too low or too high.
• Charging has gone on too long without
completion (typically eight hours).
Single blinking amber (when the device is
turned on)
Battery depleted
Radio Status LED
Slow blinking green
All those radio devices which are powered on are
available for receiving / sending data.
Slow blinking red
Any one of the radio devices which is powered on
and not available for receiving / sending data.
Off All radio off
NOTE
For information about scanning/decoding, see Data Capture on Page 43. For information about
WAN radio status and settings, see Chapter 6, Using the Phone.
Comentarios a estos manuales