Motorola LD-W-1 Especificaciones descargar pdf (Pagina 19)

Locomotive decoders 30s series English

Page 19

If the lamp or the accessory is already connected with one side to

vehicle ground, the connection is complete. If not, connect the second

side of the lamp or the accessory to the return conductor of the

decoder (point RL).

Caution:

If you connect the accessories to the return conductor for all functions

(point RL), the accessories must be insulated. The accessories should

not make contact with metal parts of the vehicle. Possible short circuit!

The decoder will be damaged in operation. The overload protection of

the decoders LD-G-30, LD-G-33 and LD-G-34 cannot protect them from

being so damaged.

Caution:

The return conductor for all functions (point RL) must under no

circumstances be connected to vehicle ground. Possible short circuit!

The decoder will be damaged in operation. The overload protection of

the decoders LD-G-30, LD-G-33 and LD-G-34 cannot protect them from

being so damaged.

Tip: Before starting to program the locomotive decoder you should

connect the motor to the decoder. Otherwise there is no confirmation

signal to the (DCC-) central unit. Should you intend to program the

decoder with a Motorola central unit you should always connect the

lighting to the outputs, intended to connect the front and the back

lighting ex works. The locomotive indicates the change-over to the

programming mode and the taking-over of settings by flashing of the

lighting connected to these outputs.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Sin comentarios

Motorola LD-W-1 Especificaciones Pagina 19