Motorola LD-W-1 Especificaciones descargar pdf (Pagina 25)

Locomotive decoders 30s series English

Page 25

8. Configuration variables and registers

The following list shows all configuration variables (for the DCC format)

and registers (for the Motorola format), that can be set for the

locomotive decoders of the 30s series.

In the list you will find in the column "CV-no." the numbers of the

configuration variables for programming in DCC format and in the

column "Reg.-no." the numbers of the registers for programming in

Motorola format. The defaults are those values set in the state of

delivery and after a reset.

For some configuration variables, the input values have to be calculated

by adding the numerical values assigned to the desired parameters.

Name of CVs /

Registers

CV-

no.

Reg.

no.

Input value

(Default)

Remarks and Tips

Basic address 1 01 1 ... 255

(3)

Range of values in

DCC-Format: 1 ... 127

Tip: If a value higher than 127 is set for the basic address and the use of

extended addresses in CV#29 is set to off, the decoder does not react to signals

in DCC format!

Starting

voltage

2 47 0 ... 255

(LD-G-30: 5)

(LD-G-31: 5)

(LD-G-32: 5)

(LD-G-33: 5)

(LD-G-34: 5)

(LD-W-32: 50)

(LD-W-33: 60)

= The voltage to be output

to the motor at speed level

1. The value "0" corresponds

to 0 Volt, the value "255" to

the max. voltage.

See "optimizing the driving

characteristics" at the end of

section 8., as well.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 51 52

Comentarios a estos manuales

Sin comentarios

Motorola LD-W-1 Especificaciones Pagina 25

Comentarios a estos manuales