
5 - 8 WT41N0 User Guide
RS409/RS419 Scanner
To connect the RS409 or RS419 scanner to the wearable terminal:
1. Remove the rubber plug from the wearable terminal interface connector.
2. Connect the scanner interface cable to the wearable terminal interface connector. If the wearable terminal
is mounted on the arm, connect the cable to the interface connector closest to the wrist.
Figure 5-4
Connecting Scanner to Wearable Terminal
3. If using the extended cable configuration, route the scanner cable up to the shoulder and down to the hand
that the scanner mounts on. Attach two cable clips to clothing and secure cable to cable clip.
Figure 5-5
Cable Clip Installation
4. Rotate the trigger assembly to the correct position for the hand that the scanner mounts to.
NOTE There are two scanner configurations available. The short cable configuration connects the scanner to the
wearable terminal mounted on the arm. The extended cable configuration connects the scanner to the
WT41N0 mounted on the hip.
Scanner Cable Connector
Interface Connector
Comentarios a estos manuales