Motorola Canopy Backhaul Module Guía de usuario descargar pdf (Pagina 175)

100

101

Building Your Canopy Network March 2005

Through Software Release 6.1

Issue 1 Page 175 of 425

Canopy System User Guide

Powered

A red dot indicates that the port is powered with 24 V DC to provide power to an AP or

BH. A grey dot indicates that the port is not powered. Port power is turned on and off in

the Port Power Control parameter of the Configuration page. A CMMmicro comes from

the factory with no Ethernet ports powered.

CAUTION!

Never connect any devices other than Canopy APs and BHs to a

powered port. Powered ports are indicated by a red LED to the right of

the port. (See Item 7 in Figure 64 on Page 172.) A powered port has 24-

V DC on Pins 7 and 8 and 24-V return on Pins 4 and 5. This can

damage other networking equipment, such as a computer or a router.

Device Type

This field displays the MAC address of the CMMmicro.

PLD Version

This field displays the version of the PLD (Programmable Logic Device) that is installed in

the module. Before you request technical support, note this information.

Software Version

This field displays the version of the software that is installed in the module. Before you

request technical support, note this information.

System Time

This field displays the current time. If the CMMmicro receives the signal from a GPS

antenna, then this field expresses the time in Greenwich Mean Time (GMT).

Satellites Visible

This field displays how many satellites the GPS antenna sees.



NOTE:

This differs from the Satellites Tracked field (described below).

Latitude

If the CMMmicro receives the signal from a GPS antenna, then this field displays the

latitude of the site.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 424 425

Comentarios a estos manuales

Sin comentarios

Motorola Canopy Backhaul Module Guía de usuario Pagina 175

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Motorola Canopy Backhaul Module