Motorola Canopy Backhaul Module Guía de usuario descargar pdf (Pagina 263)

100

101

Building Your Canopy Network March 2005

Through Software Release 6.1

Issue 1 Page 263 of 425

Canopy System User Guide

5. If the support structure is a pole that has an outside diameter of 3 to 8 cm, or

1.25 to 3 inches, use a toothed V-bracket (provided) to

a. attach the V-bracket to the pole as shown in Figure 100.

b. attach the CMM2 flanges to the V-bracket.

Figure 100: Detail of pole mounting

end of procedure

19.5.4 Cabling a CMM2

IMPORTANT!

Where you deploy CMM2s, one AP in each AP cluster must be

connected to the master port on the CMM2, and each module connected

to a CMM2 must be configured to Sync to Received Signal (Timing

Port). If either is not done, then the GPS receiver sends no sync pulse to

the remaining ports.

Perform the following procedure to attach the CMM2 cables on both ends:

Procedure 26: Cabling the CMM2

1. Remove the base cover from any AP or BH that is to be connected to this CMM2.

See Figure 47 on Page 132.

2. Remove the GPS sync cable knockout from the base cover.

3. For any AP that is to be connected to this CMM2, set the AP Sync Input

Configuration Page parameter to the Sync to Received Signal (Timing Port)

selection.

4. Review the schematic drawing inside the CMM2.

1 2 ... 258 259 260 261 262 263 264 265 266 267 268 ... 424 425

Comentarios a estos manuales

Sin comentarios

Motorola Canopy Backhaul Module Guía de usuario Pagina 263

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Motorola Canopy Backhaul Module