Motorola SG4-DRT-2X Instrucciones de operaciones Pagina 94

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 108
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 93
5-4 Installation
SG4000 Installation and Operation Manual
6
Connect each fiber by removing the protective boot from the fiber connector, cleaning the
connector with pure isopropyl alcohol (99%) using a lint-free wipe, and drying it with filtered
compressed air.
7 After cleaning the fiber, insert it into the appropriate receiver or transmitter module.
8 Position the fiber service cable in the compression fitting to provide some slack in the fibers
inside the housing.
9 Tighten the compression nut until it bottoms out.
10 Finally, tighten the water seal nut until there is no gap between it and the compression nut.
Standard Strand Wire Mounting
Two strand clamps and bolt assemblies are located on top of the housing for normal horizontal
mounting below the strand. Figure 5-4 illustrates a top view of the strand mounting clamps.
Figure 5-4
Strand mounting clamps – top view
Clamps
Vista de pagina 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 107 108

Comentarios a estos manuales

Sin comentarios