Motorola SG4-DRT-2X Instrucciones de operaciones descargar pdf (Pagina 95)

Installation 5-5

SG4000 Installation and Operation Manual

Figure 5-5 illustrates a front and side view of the strand mounting clamps.

Figure 5-5

Strand mounting clamps – front and side view

456

Clamps Clamp

To mount the SG4000 to the strand wire:

1 Loosen the 5/16 × 18 strand clamp bolt located on each mounting bracket.

2 Lift the node such that the clamps are level with the strand and slide the node back until

the strand engages the strand clamps.

Do not tighten the hex-head bolts at this time. This enables the clamps to slide along the

strand wire until the housing is finally positioned with respect to the cables.

3 Verify that the node is within 5 degrees of hanging straight up and down.

3 When the housing is in the required position, torque the two strand clamp bolts to

10 to 12 ft-lbs.

4 Re-install any modules and electronic components that were removed before the housing

was installed.

Optional Strand Bracket Mounting

In applications where a vertical approach to mounting the node is preferred, you can use the

SG2-style strand bracket assembly. This optional kit contains one mounting bracket, two spacer

blocks, and two 5/16 × 18 bolts. You can order this bracket kit through your local Motorola sales

representative.

To install the optional strand bracket and mount the SG4000:

1 Remove the factory-installed strand clamps.

2 Remove the components from the kit and position them as illustrated in Figure 5-6.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 107 108

Sin comentarios

Motorola SG4-DRT-2X Instrucciones de operaciones Pagina 95