Motorola 7545MBWM Guía de usuario descargar pdf (Pagina 149)

Settings 4 - 35

Connect: Used to connect to an already existing wireless network configuration.

Add New: Use

d to create a new wireless network configuration.

Edit: Use

d to change values in an existing wireless network configuration.

Remove:

Used to delete a wireless network configuration.

Scan:

Used to detect and list available wireless networks. You can highlight a network in the list, and tap

on Add New to activate the network.

There are two methods available when config

uring a radio network – you can either scan for an existing

network or manually create a network. If you tap on the Scan button, a list of networks detected by the radio is

displayed. Highlighting one of the listed networks and tapping on the Add New button creates a new profile that

is completed based on the security capabilities detected by the radio. You may need to add additional informa-

tion, depending on your network requirements.

If you tap on the Add New button r

ather than the Scan button, you can create a network manually.

Manually Creating a Network

• In the Configure tab, tap on the Add New button.

• Enter the SSID (Service S

et Identifier) for your network.

IMPORTANT The steps below describe how to manually create a network. Keep in

mind that this is intended only as an example

and may vary from your

own network requirements. If, for example, you are using a different

type of security for your network, the fields you complete may not

match those described here.

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 349 350

Sin comentarios

Motorola 7545MBWM Guía de usuario Pagina 149