
Accessories 5 - 9
Figure 5-8
ST3113 Vehicle Power Outlet Adaptor
• Attach a Snap Module to the base of the hand-held. Refer to “Snap Modules” on page 5-6 if you require
further details.
• Insert the DC power plug on the Vehicle Power Outlet Ad
aptor into the DC IN port on the Snap Module.
• Insert the Vehicle Power Outlet Adaptor plug into au
tomotive power outlet in your vehicle.
Chargers and Docking Stations: General Information
Important Charger Safety Instructions
Charging the Battery
Omnii Hand-Held Computer operates with lithium-ion battery pack Model ST3001. Preparing the unit for oper-
ation requires that the battery pack be charged and installed in the hand-held.
Batteries shipped from the factory are charged to approximately 40
% of capacity. Lithium-ion battery packs
must be fully charged before use. These batteries can be charged with a variety of chargers and docking
stations. Currently the following are available:
• The Snap Module is a mobile adaptor for Omnii. Three models are available — see “Snap Modules” on
page 5-6.
• The AC Wall Adaptor operates as an AC power source an
d also charges the battery installed in the unit —
see “AC Wall Adaptor - Models ST1050 and ST1050-AR” on page 5-8.
• The Vehicle Power Outlet Adaptor powers Omnii and re
charges the battery using power drawn from your
vehicle’s automotive power outlet — see “Vehicle Power Outlet Adaptor - Model ST3113” on page 5-8.
• The Desktop Docking Stations operate as both chargers and docking stations. Operating as a charger,
b
oth the battery installed in Omnii and a spare battery can be charged. Priority is given to charging the
hand-held's battery. See “Desktop Docking Stations - Models ST4002 and ST4003” on page 5-10.
DC power plug
Adaptor plug
NOTE Battery charging continues whether the hand-held is switched on or off.
IMPORTANT Before charging a battery with a desktop docking station, it is critical
that you review the safety guidelines in the Omnii Hand-Held Com-
puter Regulatory & Warranty Guide (PN 8000191) and the Omnii
Hand-Held Accessories Regulatory & Warranty Guide (PN
8000205).
Comentarios a estos manuales