Motorola 7545MBWM Guía de usuario descargar pdf (Pagina 243)

Accessories 5 - 23

Figure 5-20

Connecting to vehicle power

For a diagram of a power with communications setup, see Figure 5-21 Connecting ST1002 to vehicle power

and communications in a typical setup on page 5-25.

The Omnii charging LED (see “Battery Charge Status LED” on page 2-15) indicates that external power is

available, and it also indicates the cha

rging status of the internal battery.

Wiring Guidelines

Before installing the cables between the cradle and other devices, consider the following:

• Ensure that drilling holes will not damage

the vehicle or its wiring.

• Protect cable runs from pinching, overheating and physical damage.

• Use grommets to protect cables that pass through metal.

• Use plastic straps and tie-downs to secur

e cables and connectors in their desired location, away from

areas where they may get snagged or pulled.

• Keep cables away from heat sources, grease,

battery acid and other potential hazards.

• Keep cables away from control pedals and other moving p

arts that may damage the cables or interfere

with the operation of the vehicle.

Installation in High Voltage Vehicles

Due to the hazardous voltages present on these vehicles, it is necessary to ensure that the powered cradle

power supply cable connector is not accessible to the vehicle operator, and does not get exposed to water

or other liquids. Exp

osing an accessible power connector to water or other liquids could create a

hazardous situation resulting in serious injury or death. Avoiding this hazard can be accomplished in the

following way.

• Use the PS1350 pre-regulator or, for freezer applications (-30°C), the PS1370 pre-regulator.

CA3001 Vehicle Cradle Power

and Communications Cable

CA3000 Vehicle Cradle

Power Cable

WARNING Voltages exceeding 30VDC are considered hazardous. Installation

of powered cradles in vehicles that operate above 30VDC require

special consideration, as listed below.

1 2 ... 238 239 240 241 242 243 244 245 246 247 248 ... 349 350

Sin comentarios

Motorola 7545MBWM Guía de usuario Pagina 243