
Accessories 5 - 5
The Hand Strap - Model ST6025
• Attach the strap to the two threaded inserts located at the back of the hand-held near the top of the unit
(see Figure 5-3 Attaching the hand strap), using the two Phillips head screws provided with this
accessory.
• Stretch the handstrap toward the base of the hand-held, and hook the clip at the bottom of the handstrap
into the slot near the base of the battery pack.
Figure 5-3
Attaching the hand strap
Protective Carrying Case - Model ST6090
A carrying case is available for Omnii to shield the unit from damage. It is compatible with the hand strap. A
variety of cases are available, depending on the type of end-cap attached to your unit.
Hard Shell Holster - Model ST6055
A hard shell holster that includes a belt, leg tie-down, and tether, can be used to hang Omnii with a pistol grip
from your waist. Note that holsters are designed for both right- and left-handed use.
• Feed the belt through the top panel of the holster, and adjust the belt as needed.
• If using the leg tie-down strap, wrap it around your leg an
d snap the buckle closed. Adjust the tightness of
the strap for security and comfort.
Screen Protector RV6105
Rubber Boot:
Yellow – Standard back covers A & B
Grey – Standard back covers A & B
Yellow – Expansion Back Covers
Grey – Expansion Back Covers
Yellow – Expansion Back Covers, WWAN
End-cap
Grey – Expansion Back Covers, WWAN
End-cap
Blue - Freezer Standard Back Covers
ST6080
ST6081
ST6082
ST6083
ST6084
ST6085
ST6086
Accessory Model Number
Comentarios a estos manuales