Motorola 7545MBWM Guía de usuario Pagina 327

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 350
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 326
Omnii XT15f Freezer Variants F - 11
Display and Scan Window Heaters
This section displays information on the individual heaters.
Status
These LED status indicators report the heating mode for each individual heater.
Current
This indicates the average current drawn at th
e moment for the individual heater.
Power
This indicates the power used at the moment for each individual heater.
Temperature
This shows the temperature measured near the heating eleme
nt. Note that the temperature units (C or F) can
be selected at the top of the Heater Info tab. Once set, the selection is stored.
System Test
The system test feature allows the user to test the functionality of all available heaters (for approximately 20
seconds) to make sure that the heating system – heaters and control board – are working properly.
NOTE If the scanner/imager is not connected, the scan window heater will be disabled
(greyed out).
LED Description
Blue indicates that the heating element is operating in full power mode.
Green indicates that the heating element is operating in sustaining mode.
Grey indicates that the heating element is off.
Red indicates that there is a hardware failure with the heater.
Vista de pagina 326
1 2 ... 322 323 324 325 326 327 328 329 330 331 332 ... 349 350

Comentarios a estos manuales

Sin comentarios