Motorola 7545MBWM Guía de usuario Pagina 242

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 350
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 241
5 - 22 Omnii (Windows Embedded Hand-Held 6.5) User Guide
Figure 5-19
Inserting Omnii into the vehicle cradle
Maintaining the Vehicle Cradle
Two latches in the cradle hold Omnii firmly in place. Although these latches are designed for at least 100,000
insertion and removal cycles, they will wear over time and will no longer lock Omnii securely in the cradle. For
replacement parts and instructions contact Motorola. Partial disassembly is required.
ST1002 Powered Cradle Installation
The ST1002 cradle is designed to allow Omnii to be powered by a vehicle battery. The battery installed in
Omnii is also recharged by the vehicle battery. This option accepts DC power sources over the range 11.5V to
30V. Voltages above that require the use of the preregulator (Model No. PS1350).
The ST1002 Vehicle Cradle has a 44-pin connector that allows connection with either the CA3001 Vehicle
Cradle Power and Communications Cable (DE9M serial port, 2 USB Host interfaces, and power cable) or the
power-only CA3000 Vehicle Cradle Power Cable. For connector pinouts and a cable connections diagram, see
“Cable Connectors for Vehicle Cradle Model ST1002” on page A-5.
Release button
WARNING Applying a voltage greater than that specified, or reversing polarity, may
result in permanent damage to the cradle power option and will void the
product warranty.
Operating an Omnii XT15f Arctic unit in operating temperatures from
-30°C to +50°C, requires the use of the power preregulator Model No.
PS1370.
Vista de pagina 241
1 2 ... 237 238 239 240 241 242 243 244 245 246 247 ... 349 350

Comentarios a estos manuales

Sin comentarios