Motorola 7545MBWM Guía de usuario descargar pdf (Pagina 236)

5 - 16 Omnii (Windows Embedded Hand-Held 6.5) User Guide

Indicators

The quad docking station is equipped with Ethernet activity and link LEDs (see Figure 5-14 Ethernet network

connection on page 5-17).

Quad Docking Station Operation

Charging the Omnii Battery

• Insert the DC power plug into the ST4004 rear DC IN connector (see Figure 5-14 Ethernet network

connection on page 5-17).

The ST4004 supplies DC power to enable the Omnii internal fast charger. Normally, a full charge of the battery

will take from 3 to 4 hours.

• Insert up to four Omnii computers into the docking statio

n charging bays, pressing down gently but firmly to

seat them securely.

• During the charge, the Omnii LED slow flashes green.

• When the battery finishes charging, the LED turns solid green.

• To remove Omnii, push down on the release mechanism on the front face of the docking bay. The

hand-held will det

ach from the docking bay release arms and can be pulled up and out.

Figure 5-13

Insertion and removal of Omnii computers

Installation

Place the charger in an area that is free from excessive dirt, dust, water and other liquids, and contaminants.

The ambient temperature must be in the range 0° C and 40° C (32° F to 104° F). The doc

king station will not

charge batteries outside of this temperature range. For maximum performance, it is recommended that the

charger be operated at room temperature — a temperature range between 18°C to 25°C (64°F to 77°F).

IMPORTANT Use IEC-320 C13 power cords approved by Motorola, with the ground pin

connected to a proper earth-grounded receptacle. Check with a qualified

electrician if you are uncertain of your receptacle grounding.

NOTE Battery charging continues whether Omnii is switched on or off.

Release mechanism

Release arm

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 349 350

Sin comentarios

Motorola 7545MBWM Guía de usuario Pagina 236