Motorola 7545MBWM Guía de usuario Pagina 32

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 350
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 31
1 - 6 Omnii (Windows Embedded Hand-Held 6.5) User Guide
Battery packs shipped from the factory are charged to approximately 40% and must be fully charged prior to
use. Batteries can be charged using a variety of chargers and docking stations. For detailed information, see
“Battery Details” on page 2-5.
Replacing the Battery Pack
Figure 1-6
Omnii Battery
Assuming the default power saving parameters and battery reserve level have not been altered, a battery can
be removed for up to 4 minutes without losing data. After 4 minutes the hand-held may reboot.
Removing the Battery Pack
If your unit is equipped with a hand strap, unhook it from the base of the battery.
Press the two latch buttons at the sides of the comp
artment simultaneously, and slide the battery out.
Installing the Battery Pack
Slide the charged battery with the contoured plastic facing you into the unit with the contacts matching
p
osition and the guide tabs moving into the corresponding slots at the base of the compartment. Firmly
click both sides of the battery into place.
If your computer is equipped with a hand strap, re-attach th
e clip to the slot at the base of the battery.
Switch the unit on (see “Switching the Omnii On and Off” on page 1-6).
Switching the Omnii On and Off
Follow the instructions below for your Omnii.
IMPORTANT Always switch the unit off before changing the battery (see “Switch-
ing the Omnii On and Off” on page 1-6). However, assuming the
default power saving parameters and battery reserve level have not
been altered, battery swap time is a minimum of 4 minutes — you
will not lose data if the battery is replaced within this time frame.
2 - Battery Compartment
Contacts
Battery top
Battery bottom
1 - Release Button
3 - Guide Tabs
4 - Release Button Tabs
3
3
3
1
1
2
4
4
NOTE If you are using a docking station or an external power supply, you can insert an
uncharged battery and use the device while the battery charges.
Vista de pagina 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 349 350

Comentarios a estos manuales

Sin comentarios