
GLOBAL CONFIGURATION COMMANDS 4 - 37
show-wireless-client-stats-
rf [average-retry-number|
error-rate|hostname|mac|
noise|q-index|
rx-rate|signal|snr|t-index|
tx-rate]
Customizes the output of (show wireless client stats rf) commands
• average-retry-number – Displays the average retry number per packet
• error-rate – Displays the error rate
• hostname – Displays the hostname of the client – Configured by
sniffing packets or manually
• mac – The MAC address of client
• noise – Displays the noise level measured in dBm
• q-index – Q-Index
• rx-rate – Displays the rate of radio packets received
• signal – Displays the signal strength in dBm
• snr – Displays the Signal to Noise Ratio (SNR) in db
• t-index – T-index
• tx-rate – Displays the rate at which radio packets are transmitted
show-wireless-radio [adopt-
to|
ap-name|channel|location|
num-clients|power|
radio-alias|radio-id|
radio-mac|rf-mode|state]
Customizes the output of (show wireless radio) commands
• adopt-to – Displays the name of the Controller to which the client radio
is adopted
• ap-name – Hostname of the AP to which this radio belongs
• channel – The configured and current channel of the radio
• location – Location of the AP to which this radio belongs
• num-clients – Number of clients associated with this radio
• power – The configured and current transmit power of the radio
• radio-alias – Consists of the AP's hostname and the radio interface
number in the form of hostname:RX
• radio-id – Consists of the AP MAC address and the radio interface
number in the form of AA-BB-CC-DD-EE-FF:RX
• radio-mac – The base MAC address of the radio
• rf-mode – The RF mode of the radio (2.4GHz-Wlan/5GHz-wlan/sensor)
• state – The current operational state of the radio
Comentarios a estos manuales