
7 - 72 WiNG CLI Reference Guide
7.1.21.14 switchport
Interface Config Instance
Sets switching mode characteristics for the selected interface
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
switchport [access|mode|trunk]
switchport access vlan <1-4094>
switchport mode [access|trunk]
switchport trunk [allowed|native]
switchport trunk allowed vlan [<VLAN-ID>|add|none|remove]
switchport trunk allowed vlan [add|remove] <VLAN-ID>
switchport trunk native [tagged|vlan <1-4094>]
Parameters
access vlan <1-4094> Configures the access VLAN of an access-mode port
• vlan <1-4094> – Sets the VLAN when interface is in access mode
mode [access|trunk] Sets the mode of the interface to access or trunk mode (can only be used
on physical (layer2) interfaces)
•access – If access mode is selected, the access VLAN is automatically
set to vlan1. In this mode, only untagged packets in the access VLAN
(vlan1) are accepted on this port. All tagged packets are discarded
• trunk – If trunk mode is selected, tagged VLAN packets VLANs are
accepted. The native vlan is automatically set to VLAN1. Untagged
packets are placed in the native VLAN by the controller. Outgoing
packets in the native VLAN are sent untagged. trunk is the default
mode for both ports.
Comentarios a estos manuales