
7 - 20 WiNG CLI Reference Guide
7.1.6.2.7 use
bridge-vlan-mode commands
Uses preconfigured access lists with this bridge policy.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
use [ip-access-list|mac-access-list]
use ip-access-list ext-vlan out <IP-ACCESS-LIST>
use mac-access-list ext-vlan out <MAC-ACCESS-LIST>
Parameters
Example
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#use ip-access-list ext-
vlan out test
rfs7000-37FABE(config-profile default-rfs7000-bridge-vlan-1)#
ip-access-list|mac-access-
list]
• ip-access-list – Uses IP access list
• mac-access-list – Uses MAC access list
• ext-vlan – Enables extended-VLAN on the selected access list
• out – Applies ACL on the outgoing packets
• <IP-ACCESS_LIST> <MAC-ACCESS-LIST> – Specify the access list
name as IP ACL or MAC ACL
NOTE: The commands write, clrscr, help, exit, end,commit, do revert, service, and show
are common for all the commands. For more information, see Chapter 5, COMMON
COMMANDS.
Comentarios a estos manuales