
7 - 94 WiNG CLI Reference Guide
link [ip <A.B.C.D>|listen||vlan
<1-4095>] <A.B.C.D>
{adjacency-hold-time <2-
600>|cost <1-10000>|hello-
interval <1-120>|level [1|2]}
Creates a MiNT routing link
• ip <A.B.C.D> – Creates a MiNT tunnel over UDP/IP
• <A.B.C.D> – Specifies a peer IP address
• listen<A.B.C.D> – Creates listening link over UDP/IP
• <A.B.C.D> – Specifies a listening IP address
• vlan <1-4095> – Enables MiNT routing on a VLAN
• <1-4095> – Specifies a VLAN index value
The following parametrs are common for all the above:
• adjacency-hold-time <2-600> – Adjacency lifetime after hello
packets cease
• <2-600> – Specifies the lifetime in seconds
• cost <1-10000> – Specifies the link cost
• <1-10000> – Specifies the cost in arbitrary units
• hello-interval <1-120> – Hello packet interval
• <1-120> – Specifies the number of seconds between hello
packets
• level[1|2] – Specifies existing routing levels
• 1 – Level 1 only (local)
• 2 – Level 2 only (inter-site)
mlcp [l2|l3] Configures the MINT link creation protocol
• l2 – MLCP over Layer 2 (VLAN) links
• l3 – MLCP over Layer 3 (IP) links
spf-latency <0-60> Latency of SPF routing recalculation
• <0-60> – Specifies the latency in seconds
Comentarios a estos manuales