
SHOW COMMANDS 6 - 17
6.1.7 cdp
show commands
Displays Cisco Discovery Protocol (CDP) neighbor table
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
show cdp neighbors {on <DEVICE-NAME>}
Parameters
Example
rfs4000-22CDAA(config)#sh cdp neighbors on rfs4000-22CDAA
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater
-------------------------------------------------------------------------- DEVICE ID
LPORT TTL CAPABILITY PLATFORM PORT ID
-------------------------------------------------------------------------- Switch
ge1 170 R S I cisco WS-C3560-24PS FastEthernet0/2
-------------------------------------------------------------------------
neighbors {on <DEVICE-NAME>} Displays the CDP neighbor table
• {on <DEVICE-NAME>} – On AP/Controller
• <DEVICE-NAME> – On AP/Controller name
Comentarios a estos manuales