
26 - 5
26.1.3 Using the Command Line Interface to Configure the WLAN
Creating a First Controller Managed WLAN
These instructions are for configuring your first WLAN using the Wireless Controller’s command line interface (CLI).
Use a serial console cable when connecting to the wireless controller for the first time. Set the following configuration
when using the serial connection.
• Bits per second: 19200
• Data Bit: 8
• Parity: None
• Stop Bit: 1
• Flow Control: None
The general steps involved in creating a WLAN on a wireless controller can be summarized as:
1. Logging Into the Controller for the First Time
2. Creating a RF Domain
3. Creating a Wireless Controller Profile
4. Creating an AP Profile
5. Creating a DHCP Server Policy
Comentarios a estos manuales