
PROFILES 7 - 93
7.1.31 mint
Creating Profiles
Configures MiNT protocol commands
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
mint [dis||level|link|mlcp|spf-latency]
mint dispriority-adjustment <-255-255>
mint level [leve11|leve2] area-id <1-4294967295>
mint link [ip|listen|vlan]
mint link listen ip <A.B.C.D> {adjacency-hold-time <2-600>|cost
<1-10000>|hello-interval <1-120>|level [1|2]}
mint link [ip <A.B.C.D>|vlan <1-4095>] > {adjacency-hold-time <2-600>|cost <1-
10000>|hello-interval <1-120>|level [1||2]}
mint mlcp [l2|l3]
mint spf-latency <0-60>
Parameters
dis[ priority-adjustment <-255-
255>|scatter]
Sets the relative priority for the router to become DIS
• priority-adjustment <-255-255> – Sets adjustment added to base
priority
• <-255-255> – Priority adjustment value, added to fixed the base
priority. Higher numbers result in higher priorities.
level [leve1|leve2] area-id <1-
4294967295>
Configures MiNT routing levels
• leve1 – Configures local MiNT routing
• leve2 – Configures inter-site MiNT routing
The following parameters are common for the above:
• area-id – Specifies a routing area identifier
• <1-4294967295> – Specifies an area identifier value
Comentarios a estos manuales