
21 - 10 WiNG CLI Reference Guide
21.1.8 interference-recovery
smart-rf-policy
Recovers detected problems due to excessive noise and interference
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
interference-recovery {channel-hold-time <0-86400> |channel-switch-delta
[2.4Ghz|5Ghz] <5-35>|client-threshold <1-255>|interference|noise}
Parameters
Example
rfs7000-37FABE(config-smart-rf-policy-test)#interference-recovery channel-switch-
delta 5 5
rfs7000-37FABE(config-smart-rf-policy-test)#
rfs7000-37FABE(config-smart-rf-policy-test)#interference-recovery interference
rfs7000-37FABE(config-smart-rf-policy-test)#
rfs7000-37FABE(config-smart-rf-policy-test)#interference-recovery retry-threshold
0.9
rfs7000-37FABE(config-smart-rf-policy-test)#
channel-hold-time <0-86400> Defines the minimum time between two channel change recoveries
• <0-86400> – Sets the time between channel change assignments
based on interference/noise in seconds
channel-switch-delta
[2.4Ghz|5Ghz] <5-35>
Specifies the difference between the current and best channel
interference for a channel change
• 2.4Ghz|5Ghz] <5-35> – Select the bandwidth as 2.4Ghz or 5Ghz
• <5-35> – Specify the difference in dbm by selecting a value
between 5 and 35
interference Considers the external interference values for performing interference
recovery
noise Considers the noise values for performing interference recovery
client-threshold <1-255> Specifies client thresholds associated after which, a channel change
due to interference recovery is avoided
• <1-255> – Specify the number of clients between 1 and 255
Comentarios a estos manuales