
4 - 98 WiNG CLI Reference Guide
4.1.36.2.3layout
rf-domain-mode
Configure layout maps for every rf-domain/floor/area. It allows users to place APs across the deployment map. A maximum
of 256 layouts will be permitted.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
layout map-location <WORD> units [feet|meters] {area|floor} <WORD>
Parameters
Example
rfs7000-37FABE(config-rf-domain-default)#layout map-location www.firstfloor.com
units meters area Ecospace floor Floor5
rfs7000-37FABE(config-rf-domain-default)#
rfs7000-37FABE(config-rf-domain-default)#show context
rf-domain default
country-code us
sensor-server 1 ip 172.16.10.14 port 1
channel-list dynamic
channel-list 2.4GHz 1,2,3,4,5,6,7,8,9,10
layout map-location www.firstfloor.com units meters area Ecospace floor Floor5
rfs7000-37FABE(config-rf-domain-default)#
map-location <WORD> units
[feet|meters] {area |floor}
<WORD>
• map-location <WORD> – Configures map-location for the layout
• <WORD> – Specify the URL to configure
• units [feet|meters] – Configures map units in terms of feet/meters
• feet – Specify the measurement in feet
• meters – Specify the measurement in meters
• {area <WORD> – Configures area name for the layout
• floor <WORD> – Configures floor name for the layout
NOTE: The remaining commands under rf-domain are same as Device-Mode
Commands. For more information, see Chapter 7, Device Specific Commands.
Comentarios a estos manuales