
7 - 12 WiNG CLI Reference Guide
7.1.6.1 bridge
bridge commands
Configures bridge specific commands
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
bridge vlan <1-4095>
Parameters
Usage Guidelines
Creating customized filter schemes for bridged networks limits the amount of unnecessary traffic processed and
distributed by the bridging equipment.
If a bridge does not hear bridge protocol data units (BPDUs) from the root bridge within the specified interval, defined in
the max-age (seconds) parameter, assume the network has changed and recomputed the spanning-tree topology.
Example
rfs7000-37FABE(config-profile-default-rfs7000)#bridge vlan 5
rfs7000-37FABE(config-profile-default-rfs7000)#
Switch Note: The interfaces mentioned below are supported as follows:
• ge <index> – RFS7000 and RFS4000 supports 4 GEs, RFS6000 supports 8 GEs
• me1– Only supported on RFS7000 and RFS6000
vlan <1-4095> Enter a VLAN index value between 1 and 4095
Comentarios a estos manuales