
CHAPTER 24 INTERFACE-RADIO
COMMANDS
Use the (config-profile-default-rfs4000) instance to configure radio instances associated with the controller.
To switch to this mode, use:
rfs4000-37FABE(config-profile-default-rfs4000)#interface radio ?
1 Radio interface 1
2 Radio interface 2
3 Radio interface 3
rfs4000-37FABE(config-profile-default-rfs4000)#interface radio
rfs4000-37FABE(config-profile-default-rfs4000-if-radio1)#?
Radio Mode commands:
aggregation Configure 802.11n aggregation related parameters
airtime-fairness Enable fair access to medium for clients based on
their usage of airtime
antenna-diversity Transmit antenna diversity for non-11n rates
antenna-gain Specifies the antenna gain of this radio
antenna-mode Configure the antenna mode (number of transmit
and
receive antennas) on the radio
beacon Configure beacon parameters
channel Configure the channel of operation for this radio
data-rates Specify the 802.11 rates to be supported on this
radio
description Configure a description for this radio
dynamic-chain-selection Automatic antenna-mode selection (single
antenna
for non-11n transmit rates)
guard-interval Configure the 802.11n guard interval
lock-rf-mode Retain user configured rf-mode setting for this
radio
max-clients Maximum number of wireless clients allowed to
associate
mesh Configure radio mesh parameters
no Negate a command or set its defaults
non-unicast Configure handling of non-unicast frames
off-channel-scan Enable off-channel scanning on the radio
placement Configure the location where this radio is
operating
Comentarios a estos manuales