Motorola 2.1 Guía de instalación Pagina 494

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 952
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 493
7 - 56 WiNG CLI Reference Guide
7.1.21 Interface Config Instance
Use the (config-profile-default-rfs7000) instance to configure the interfaces – Ethernet, VLAN and tunnel associated with
the controller.
To switch to this mode, use the following command:
rfs7000-37FABE(config-profile-default-rfs7000)#interface [<interface-name>|fe<1-4>|ge <1-
4>|me1|port-channel <1-4>|radio|up1|vlan <1-4094>|wwan1]
rfs7000-37FABE(config-profile-default-rfs7000)# ge
1
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#?
Interface Config commands:
cdp Enable Cisco Discovery Protocol on port
channel-group Channel group commands
description Interface specific description
dot1x 802.1X Authentication
duplex Set duplex to interface
ip Internet Protocol (IP)
no Negate a command or set its defaults
power PoE Command
qos Quality of service
shutdown Shutdown the selected interface
spanning-tree Spanning tree commands
speed Configure speed
switchport Set switching mode characteristics
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#
Table 7.7 Summarizes the Interface Config Commands
Table 7.7 Interface Config Commands
Command Description Reference
cdp Enables the Cisco Discovery Protocol
(CDP) on ports
page 7-58
channel-group Configures channel-group commands page 7-59
description Creates an interface specific description page 7-60
dot1x Configures 802.1X authentication settings page 7-61
duplex Specifies the duplex mode for the
interface
page 7-62
ip Sets the IP address for the assigned Fast
Ethernet interface (ME), and VLAN
Interface
page 7-63
lldp Configures Link Local Discovery Protocol page 7-64
no Negates a command or sets its defaults page 7-65
Vista de pagina 493
1 2 ... 489 490 491 492 493 494 495 496 497 498 499 ... 951 952

Comentarios a estos manuales

Sin comentarios