Motorola 2.1 Guía de instalación Pagina 504

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 952
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 503
7 - 66 WiNG CLI Reference Guide
7.1.21.9 power
Interface Config Instance
Invokes PoE commands to configure the PoE power limit and port priority. By default, the value for a GE port is set to low.
Power is applied in order of priority, power overlaods are removed in the reverse order of priority.
Supported in the following platforms:
RFS6000
RFS4000
AP71xx
AP650
AP6511
AP6532
Syntax
power {limit <0-40>|prority}
power priority [critical|high|low]
Parameters
Usage Guidelines
Use [no] power to rollback the PoE configurations and set back the default configuration
Example
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#power priority critical
% Error: No POE support on device type [rfs7000].
rfs7000-37FABE(config-profile-default-rfs7000-if-ge1)#
Switch Note: This command is not supported on the RFS7000 controller.
limit <0-40> Sets the power limit on the given port to the stated power in Watts. Select
the power limit value between 0-40 (Watts). It actually limits to 29.7W
priority [critical|high|low] Sets PoE priority for port
critical – Sets the PoE priority as a critical priority
high – Sets the PoE priority as a high priority
low – Sets the PoE priority as a low priority
Vista de pagina 503
1 2 ... 499 500 501 502 503 504 505 506 507 508 509 ... 951 952

Comentarios a estos manuales

Sin comentarios