
CHAPTER 21 SMART-RF-POLICY
This chapter summarizes Smart RF Policy commands within the CLI structure.
Use the (config) instance to configure Smart RF Policy related configuration commands. To navigate to the smart-rf-policy
instance, use the following commands:
rfs7000-37FABE(config)#smart-rf-policy <policy name>
rfs7000-37FABE(config)#smart-rf-policy test
rfs7000-37FABE(config-smart-rf-policy-test)#?
Smart RF Mode commands:
assignable-power Specify the assignable power during power-assignment
auto-assign-sensor Allow smart-rf to select optimal sensor radios for
wips and unauthorized ap detection
channel-list Select channel list for smart-rf
channel-width Select channel width for smart-rf
coverage-hole-recovery Recover from coverage hole
enable Enable this smart-rf policy
group-by Configure grouping parameters
interference-recovery Recover issues due to excessive noise and
interference
neighbor-recovery Recover issues due to faulty neighbor radios
no Negate a command or set its defaults
sensitivity Configure smart-rf sensitivity (Modifies various
other smart-rf configuration items)
smart-ocs-monitoring Smart off channel scanning
clrscr Clears the display screen
commit Commit all changes made in this session
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-smart-rf-policy-test)#
Comentarios a estos manuales