Motorola 2.1 Guía de instalación Pagina 666

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 952
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 665
12 - 34 WiNG CLI Reference Guide
The controller (by default) does not allow layer 2 traffic to pass through the interface. To adopt an access point through an
interface, configure an access control list to allow an Ethernet WISP
Use the mark option to specify the type of service (tos) and priority value. The tos value is marked in the IP header and the
802.1p priority value is marked in the dot1q frame.
Whenever the interface receives the packet, its content is checked against all the ACEs in the ACL. It is marked based on
the ACLs configuration
Example
rfs7000-37FABE(config-mac-acl-test)#permit any any vlan 2 log rule-precedence 5 rule-
description testrule
rfs7000-37FABE(config-mac-acl-test)#
NOTE: To apply an IP based ACL to an interface, a MAC access list entry is mandatory to
allow ARP. A MAC ACL always takes precedence over IP based ACLs.
Vista de pagina 665
1 2 ... 661 662 663 664 665 666 667 668 669 670 671 ... 951 952

Comentarios a estos manuales

Sin comentarios